Backplate Installation Guide for Unihertz Titan2
How to install your Unihertz Titan2 Backplate
This guide explains how to properly install the Backplate for Unihertz Titan2.
The backplate is designed as a standalone accessory for the Unihertz Titan2 and is not intended to be used together with the MCase.
Step 1 · Prepare the parts
Place the Unihertz Titan2 backplate and the adhesive stickers on the included embossed kraft paper.
Step 2 · Peel only the adhesive you need
The adhesive set includes:
-
8 rectangular short adhesive strips
-
1 full-size adhesive sheet
-
1 round adhesive sticker
Peel off only the adhesive pieces required for your chosen installation method.
You do not need to use all stickers.
Step 3 · Select your installation mode
Everyday Use Mode (Recommended)
-
Use four short rectangular adhesive strips
-
Apply them to the four corners of the backplate
-
This provides a secure hold while allowing easier removal or replacement when needed
Ultra Secure Mode (Long-Term Use)
-
If you plan to keep the backplate installed long-term
-
Use the full-size adhesive sheet
-
This provides maximum holding strength and overall stability
The round adhesive sticker is optional and can be applied or omitted depending on your personal preference.
Step 4 · Align the backplate on your Unihertz Titan2
After applying the adhesive:
-
Gently place the backplate onto the back of your Unihertz Titan2 phone
-
Start alignment from the top edge
-
Use the camera module and rear display as reference points
-
Adjust the position until all edges are flush with the phone frame
-
Once aligned, lightly lay the backplate flat against the phone
Proper alignment ensures a clean appearance and stable fit.
Step 5 · Press to secure
Once the position is confirmed:
-
Press firmly on the areas where the adhesive is applied
-
Ensure full contact between the backplate and the phone surface
-
Installation is complete
To remove or replace the backplate, gently lift from the edge and peel off slowly.